TinkerKit Touch Sensor module Ver más grande La imagen puede diferir del original

TinkerKit Touch Sensor module

T000220

Nuevo

En Stock

5,40 €

El Touch Sensor es sensible al tacto.

Output: este modulo normalmente está a 0V, pero cuando se toca restituye 5V. Cuando se conecta a un ingreso de Arduino a través del TinkerKit Shield restituye "0" si no se toca, mientras que si se toca restituye "1023"

Decsripción del Modulo: en la parte posterior del módulo hay un amplificador de señal, un condensador, un controlador QT 100A single touch, un LED verde que indica que el módulo está alimentado correctamente y un LED amarillo cuyo brillo depende de los valores de salida del módulo.

Una vez encendido, este dispositivo realiza una autocalibración, así que si se tocara la superficie durante el encendido, no funcionaría. Para restablecerlo recomendamos interrumpir la alimentación y asegurarse de que nadie lo toque al re-encenderlo

Este modulo es un SENSOR. El conector es un OUTPUT y tiene que ser conectado a los conectores INPUT del TinkerKit Shield.

 

ejemplo de codigo


/*
  Analog input, analog output, serial output

 Reads an analog input pin; a T000220 Touch Sensor connected to I0, maps the result to a range from 0 to 255
 and uses the result to set the pulsewidth modulation (PWM) on a T010111 LED Module connected on O0.
 Also prints the results to the serial monitor.


 created 29 Dec. 2008
 Modified 4 Sep 2010
 by Tom Igoe
 modified 7 dec 2010
 by Davide Gomba

 This example code is in the public domain.

 */


 #define O0 11
 #define O1 10
 #define O2 9
 #define O3 6
 #define O4 5
 #define O5 3
 #define I0 A0
 #define I1 A1
 #define I2 A2
 #define I3 A3
 #define I4 A4
 #define I5 A5

// These constants won't change.  They're used to give names
// to the pins used:
const int analogInPin = I0;  // Analog input pin that the Touch Sensor is attached to
const int analogOutPin= O0; // Analog output pin that the LED is attached to

int sensorValue = 0;        // value read from the Touch Sensor
int outputValue = 0;        // value output to the PWM (analog out)

void setup() {
  // initialize serial communications at 9600 bps:
  Serial.begin(9600);
}

void loop() {
  // read the analog in value:
  sensorValue = analogRead(analogInPin);            
  // map it to the range of the analog out:
  outputValue = map(sensorValue, 0, 1023, 0, 255);  
  // change the analog out value:
  analogWrite(analogOutPin, outputValue);          

  // print the results to the serial monitor:
  Serial.print("sensor = " );                      
  Serial.print(sensorValue);      
  Serial.print("t output = ");      
  Serial.println(outputValue);  

  // wait 10 milliseconds before the next loop
  // for the analog-to-digital converter to settle
  // after the last reading:
  delay(10);                    
}