Este producto está disponible. Puedes hacer un pedido y lo recibirás acorde al método de envío.
Los productos Bajo Demanda los enviamos a nuestros clientes a través de un pedido.
Haz un pedido normal, nosotros lo pediremos a nuestros proveedores y te lo enviaremos en un solo envío para ahorrar costes.
Actualmente no tenemos stock pero recibiremos pronto. Puedes comprar y haremos el envío tan pronto vuelva a estar disponible (de 1 a 3 semanas).
Pedidos que incluyen productos Bajo Demanda o Back Order serán eviados cuando vuelvan a estar disponibles. Esto significa que el pedido tardará de 1 a 3 semanas en ser enviado una vez el pedido esté hecho y pagado.rnSi deseas recibir primero los productos que si están en stock, por favor realiza dos pedidos diferentes separando los productos en stock, bajo demanda o back order.
Este producto solo está disponible para búsqueda (tutoriales, esquemas...). No pueden ser comprados.
AC02680
Nuevo
Advertencia: ¡Últimos artículos en inventario!
Disponible el: 0000-00-00
Huzzah! Adafruit.io Internet of Things Feather ESP8266
Recipiente :
* Campos obligatorios
total Cancelar
OK you've signed up for Adafruit.io and you're ready to build something cool and Internet-connected. All you need is this starter kit which will get you going with lots of parts that go very well with our service and are the most common sensors and actuators you may want. Sense light, motion, humidity, temperature, and more, then send it for storage on adafruit.io! Light up LEDs, make noise, and move a motor when a trigger is detected.
This pack is designed for people who want to use the new low-cost Adafruit Feather HUZZAH with ESP8266 WiFi microcontroller and are comfortable with that platform to explore IoT. A Feather HUZZAH development board is included. An Arduino or other microcontroller is not required.
This pack DOES NOT include a standard USB micro-B cable (use any cable you have as long as its sync+charge not 'charge only'), a solderless breadboard, or a Lipoly battery (take your project on the go!) - you will need a USB cable to program and debug your HUZZAH & either USB or a Lipoly battery to power the Feather HUZZAH. You may also want a full size breadboard and some prototyping wires. Some soldering is required to assemble the Feather HUZZAH ESP8266 and HDC1008 sensor.
This pack includes:
1x Breadboard-friendly SPDT Slide Switch
1x Diffused RGB (tri-color) LED
1x Piezo Buzzer
1x Photo cell light sensor
3x 12mm Tactile Switches
1x Diffused 10mm Red LED
1x Diffused 10mm Green LED
1x 10K Trim Potentiometer
5x 10K 5% 1/4W resistors
5x 560 ohm 5% 1/4W resistors
CORZOTECH - EASY LIFE FOR INTERACTION